Autronica AutroVoice miniVES 2001, Service Manual

Page: 76 / 156

76
COMPACT VOICE ALARM SYSTEM
SERVICE MANUAL
10. Operation instructions
10.1 Control Unit
It is possible to navigate in AutroVoice miniVES series L and LN devices menu via a touch-screen LCD display and nearby control
buttons. The display shows a current VASCU system status. The menu allows the following:
» monitor VASCU system status,
» trigger loudspeaker line impedance measurement,
» check network settings,
» check software and firmware versions.
In case of damage in at least one of the system modules, the LCD display will show information about the fault.
The paragraph below describes operation instructions with an example of microphone panel configuration. The microphones are
configured on a case-by-case basis for a specific purpose. During the first training, the person responsible for starting the system
provides the microphone operation manual.
10.2 Fireman microphone
Actions described below can executed by authorize personnel only.
Sending verbal messages to given fire zones (fireman microphone)
» Open red “Evacuation” button flap and press it. At this moment VASCU will switch into alarm mode. However AutroVoice
miniVES system is not equipped with the red button protected by the flap. That means that pressing once the red button
on the front panel of AutroVoice miniVES activates the 5 seconds procedure (Evacuation button starts blinking RED) during
which the system waits for second press of the button. Finishing this two steps procedure activates Alarm Mode.
» Press a button applying to a desired zone. You can choose more than one zone. Green LEDs will light up next to selected zones.
» Press “Push to Talk” button, hold the button and speak to the microphone. To finish transmitting, release the button.
» Once the verbal message transmission has finished, the microphone status LED will go out.
» To return to normal mode, press “cancel alarm” button.
Sending verbal messages to all zones
» Open red “Evacuation” button flap and press it. VASCU will switch into alarm mode.
» Press “all zones” button. All of the green LEDs next to buttons corresponding with zones will light up.
» Press “Push to Talk” button. While holding the button, speak to the microphone. To finish transmitting, release the button.
» Once the verbal message transmission is finished, the microphone status LED will go out.
» To return to normal mode, press “cancel alarm” button.