the engine, then press
POWER
.
2. Press
MON
to display Monitor
menu. Make sure
1-Wiggle
Test
is highlighted, then
press
ENTER
.
3.
ENTER to Test
will be
displayed on the screen.
Press
ENTER
to start the wig-
gle test. (Pressing
MON
again
will take the unit out of
Monitor mode and display the
opening screen.)
4. Tap, wiggle, or move wires
and sensors to detect a fault.
5.
FAULT
will be displayed if a
fault is detected during the
test.
NO FAULT
will be displayed if
there are no faults detected
during the test.
6. Press
MON
to exit the Wiggle
Test and display the opening
screen.
NOTE:
If a fault was detected, run a
KOEO test, then check the
Memory Codes to see the error.
A
CTIVATE THE
W
IGGLE
T
EST
- F
ORD
(C
ONT
.)
Page 47
Wiggle Test Mode
FAULT
NO FAULT
AutoXray 6000
FORD ‘90 VIN=N
Summary of Contents for EX-SCAN 5000
Page 1: ...USERS MANUAL...
Page 95: ...NOTES Page 95...
Page 96: ...NOTES Page 96...
Page 97: ...NOTES Page 97...
