AutoXray EX-SCAN 5000, User Manual

Page: 61 / 97

Parameters Values Parameters Values
O2 Cross Counts Bank2 Count Shift Delay ms
O2 Sensor1 Bank1 mV Shift Solenoid A On / Off
O2 Sensor1 Bank1 Heater On / Off Shift Solenoid B On / Off
O2 Sensor1 Bank2 mV Shift Solenoid C On / Off
O2 Sensor1 Bank2 Heater On / Off Short Term Trim Bank1 Percentage
O2 Sensor2 Bank1 mV Short Term Trim Bank Percentage
O2 Sensor2 Bank1 Heater On / Off Spark Advance Degrees
O2 Sensor2 Bank2 mV ST Fuel Trim Bank1 Percentage
O2 Sensor2 Bank2 Heater On / Off ST Fuel Trim Bank2 Percentage
OBD Data Cleared Km/Miles Start Up Coolant Temp C or F
OBD II Trip Completed Yes / No System Voltage Volts
Output Shaft RPM TCC Duty Cycle Percentage
Park Neutral Detected / Not Det. TCC Slippage RPM
Power Steering Load Yes / No Throttle Angle Percentage
Power Steering Sensor Volts Throttle Posn Volts
Power Take Off Engaged / Not Eng. Throttle Sensor Volts
Rear O2 Sensor Volts Total Misfires Counts
Rear O2 Trim Bank1 Percentage Trans Control Light On / Off
Rear O2 Trim Bank2 Percentage Trans Control Switch On / Off
Rev Mode Misfire Index Numeric Trans Fluid Temp Volts
Rich to Lean Avg Time mS Trans Oil Temp C or F
Rich to Lean Counts Count Turbine Shaft RPM
Rich/Ln Ln/Rich Ratio Numeric Vehicle Speed Kph/Mph
Secondary Air Pump On / Off
OBD-II O
XYGEN
S
ENSOR
T
EST
R
EADINGS
Constant Readings
Rich to Lean Sensor Threshold (Volts) - Oxygen sensor voltage that
indicates a transition from a rich condition to a lean condition.
Lean to Rich Sensor Threshold (Volts) - Oxygen sensor voltage that
indicates a transition from a lean condition to a rich condition.
Low Sensor Voltage for Switch Time Calculation (Volts) or High
Sensor Voltage for Switch Time Calculation (Volts) - The computer
uses fixed voltage levels to measure the “lean to rich” and “rich to lean”
Page 61