Automation Direct T1K-DEVNETS, User Manual

Page: 19 / 64

Installing the DeviceNet
Base Controller
Installation and
Safety Guidelines
2–6
Installing the T1K–DEVNETS Base Controller
Disable I/O Polling Diagnostics *
I/O Diagnostics SW 4
Enable OFF
Disable ON
* If DIP Switch 4 is in the OFF (default) position, you must allow for two additional
bytes on the input (RX) and two additional bytes on the output (TX) for Terminator I/O
diagnostic functions. Refer to page B–6 for the I/O diagnostic information.
Hold Outputs
Maintenance Port Baud
Rate
Maintenance Port
Protocol Selection
Outputs SW5 Baud Rate SW 6 Protocol SW7
Turn Off OFF
9600 bps OFF Normal OFF
Hold ON 19200 bps ON ASCII ON
Maintenance Port RTS/CTS Control
SW 8 RTS/CTS Description
OFF Disable RTS/CTS not available
ON Enable RTS/CTS available
Setting up the parameters of the T1K–DEVNETS will set the values to special
registers when power is applied to it. When the registers are set to the correct range,
their parameters will be stored in EEPROM, and the parameters will be retained
when power is turned off. Refer to the following table.
Parameter Table
System
V–Memory
Description Value when the scratch
pad is initialized
Range
V7614 Input register:
Starting location
V3000 V0 – V7377
V7615 Input Register:
Number of bytes
58 Bytes 0 – 128
V7616 Output Register:
Starting location
V3100 V0 – V7377
V7617 Output Register:
Number of bytes 52 Bytes 0 – 128
T1K–DEVNETS
setup parameters