Automation Direct T1K-DEVNETS, User Manual

Page: 16 / 64

Installing the DeviceNet
Base Controller
Installation and
Safety Guidelines
2–3
Installing the T1K–DEVNETS Base Controller
Use a small flat screwdriver to set the Node Address to an
available Node Address (or MAC ID), from 0 – 63. Note that X10
represents the tens place and X1 represents the units place.
Slide the module assembly onto the DIN rail until the
clip arm attaches securely to the adjacent module.
WARNING: Again, be sure that the power to the T1K Power Supply is
disconnected before installing or removing the module assemby. Failure to
disconnect power could result in serious damage to the modules, to the power
supply or to the entire assembly.
Setting the Node
Address
Connecting the
Components on
the DIN Rail