Automation Direct STRIDE SiteLink SE-SL3011, User Manual

Page: 69 / 123

STRIDE
®
SiteLink Series Industrial VPN Routers User Manual 1st Edition
3-5
Chapter 3: Controller Connection Examples
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
5. Enter the APN and PIN associated with the SIM card, then click NEXT.
6. On the WAN information screen, Click SHOW MORE to configure the Digital Input
VPN router access control if desired. Click NEXT when finished.
7. On the LAN information screen, enter the router port IP address, which must match the
default gateway entered in the CLICK PLC setup (192.168.140.1 in this example).
8. Download the configuration file. Rename it ixrouter.conf if it has been saved with a suffix.
9. Copy ixrouter.conf to the root directory of your USB stick.
10. Install the IXClient2 on your PC. (This step must be repeated for any new PC where you
will use your STRIDE SiteLink account.)
11. Mount and wire your SE-SL3011-4G router, and connect the LTE antenna.
12. With Power DISCONNECTED from the SE-SL3011-4G router, plug the SIM card into
the router.
13. Insert the USB stick into the router.
14. Power your router. Wait while the router writes the configuration and then registers itself
to the STRIDE SiteLink Server. After the router is successfully registered and connected to
the STRIDE SiteLink platform, the Status LED will be on steady blue and the Signal LED
will be on steady blue/violet/red depending on network signal strength.
15. Activate the router.
16. Now, your router will appear in the Devices list in your Stride SiteLink account.
17. Select the router from the list of devices, then click the CONNECT icon.
Configure the CLICK Software to Access the CLICK PLC via VPN
1. Open the CLICK software on your PC and select the “Connect to PLC” button.
2. Select Port Type = Ethernet and select the Outside this LAN radio button, then the Add…
button.
3. Enter a Link Name and the CLICK IP address defined previously (192.168.140.19 in this
example), then click OK.
4. Highlight your target CLICK in the devices list, then click the CONNECT button.
You should now be successfully connected to the CLICK PLC from a remote PC through the
VPN.