Automation Direct Stellar SR55 Series, User Manual

Page: 45 / 202

Chapter 3: Configuration and Parameters
Page 3–15 Stellar
®
SR55 Series Soft Starter User Manual – 1st Ed, Rev F – 09/18/2019
p
ARAmeTeR
d
eTAIls
This section describes the individual parameters and the functions that they perform.
SR55 parameters are defined as holding type registers.
p
arameTers
n
oT
C
onfigurable
T
hrough
T
ouChsCreen
m
enu
These parameters are configurable only through network communications.
p
arameTers
a
ssoCiaTed
W
iTh
d
igiTal
i
npuTs
P0.0 –
Start/Stop
(Digital Input Control Command Function) Hold. Reg. Type:
Description:
Read/Write
Starts or Stops the SR55.
• To map to digital input, refer to P10.2, P10.4, P10.6.
Range: Modbus Decimal Value: Default (decimal):
• Off : Stops or Soft Stops the SR55.
• On : Starts the SR55.
• 0
• 1
• Off (0)
Modbus Address: Modbus Format:
17920 ( 4600 hex ) 16-bit unsigned
Touchscreen Menu Path:
none
P0.1 –
Freeze Ramp
(Digital Input Control Command Function) Hold. Reg. Type:
Description:
Read/Write
If set to On, this parameter will hold the Start Ramp even if “Current I
rms
” is less than the
“Current Limit Level.”
• To map to digital input, refer to P10.2, P10.4, P10.6.
Range: Modbus Decimal Value: Default (decimal):
• Off : The Soft Start Ramp is not held and the SR55 will start in
the time set.
• On : The Soft Start Ramp is held and the SR55 will take longer
than the time set to start.
• 0
• 1
• Off (0)
Modbus Address: Modbus Format:
18240 ( 4740 hex ) 16-bit unsigned
Touchscreen Menu Path:
none
P0.2 –
Reset
(Digital Input Control Command Function) Hold. Reg. Type:
Description:
Read/Write
To reset pulse high and then low when resetting using communications.
• If using the touchscreen, the Start button will change to a Reset button during a fault condition.
• Clear the fault and press Reset.
• To map to digital input, refer to P10.2, P10.4, P10.6.
Range: Modbus Decimal Value: Default (decimal):
• Off : The final state required for a reset.
• On : The initial state required for a reset.
• 0
• 1
• Off (0)
Modbus Address: Modbus Format:
18368 ( 47C0 hex ) 16-bit unsigned
Touchscreen Menu Path:
none