877-973-3486
AWE 00192 Rev. 000
8
ACTT Xspotter Service Manual
SAFETY
INSTRUCTIONS
Before driving the vehicle, be certain
that you have read and understand the
driving and handling information in the
Operator Manual. Be certain that you
fully understand and follow all safety
warnings.
While Servicing the Vehicle
CAUTION
Read and understand the precautions
and guidelines in each component
manufacturer’s service information
before performing any service on the
components. If you are not properly
trained and certified in a procedure, ask
your supervisor for training before you
perform it.
Ground Straps and Antistatic Mats
SAFETY
INSTRUCTIONS
ALWAYS work with proper grounding
straps and antistatic mats around
electronic components.
Power Steering
SAFETY
INSTRUCTIONS
Maintain cleanliness of the power
steering hydraulic system at all times.
Clean the area around any component
prior to disconnecting or connecting.
NEVER add used power steering fluid
to the system. Dirt in the power steering
system can damage the pump or other
components.
LOCKOUT / TAGOUT PROCEDURES
WARNING
Before entering the vehicle or vehicle
body, read and follow OSHA regulations
concerning entry and working in
“CONFINED SPACE” OSHA 1910.146
and “LOCKOUT/TAGOUT” OSHA
1910.147. Follow OSHA regulations while
performing any work on the vehicle. The
vehicle must be disabled by the following
steps before performing any work on the
vehicle:
1. Place the transmission in NEUTRAL.
2. Set the parking brake.
3. Shut the engine OFF.
4. Lock the cab doors. Keep the key in your
pocket. Block the wheels before entering
the body or performing any work on the
vehicle.
5. Turn the battery disconnect switch OFF, if
equipped, and lock it in that position.
6. Completely drain the air from the
primary/A system and secondary/B
system by opening the drain valves on
the air tanks themselves or by using the
drain manifold if supplied. When draining
the air tanks, do not look into the area
where air is draining. Dirt or sludge
particles may be expelled in the air
stream and can cause eye injury.
7. Place magnetic “DANGER” signs on both
cab doors before entering the body or
performing any work on the vehicle.
8. Take proper precautions before working
under the vehicle. Use ramps approved
for the weight of your vehicle, or use floor
jacks and stands. Never work under a
vehicle or auxiliary, tag or pusher axle
supported by jacks alone. Always use
jack stands to support the vehicle and
auxiliary, tag or pusher axles.
Summary of Contents for ACTT Xspotter 2018
Page 1: ...autocartruck com Preventive Maintenance AWE 00006 Rev 005a ACTT Service Manual ...
Page 2: ......
Page 4: ...This page left blank intentionally ...
Page 59: ......