4.
Transport and storage
.
Transport to place of installation in sturdy packing.
.
Do not attach ropes or hooks to the handwheel for the purpose of lifting by
hoist.
.
If part-turn actuator is mounted on valve, attach ropes or hooks for the
purpose of lifting by hoist to valve and not to part-turn actuator.
.
Store in well-ventilated, dry room.
.
Protect against floor dampness by storage on a shelf or on a wooden
pallet.
.
Cover to protect against dust and dirt.
.
Apply suitable corrosion protection agent to bright surfaces.
If part-turn actuators are to be stored for a long time (more than 6 months),
the following points must be observed additionally:
.
Prior to storage: Protect bright surfaces, in particular the output drive parts
and mounting surface, with long-term corrosion protection agent.
.
Check for corrosion approximately every 6 months. If first signs of
corrosion show, apply new corrosion protection.
After mounting, connect part-turn actuator immediately to electrical mains,
so that condensation is prevented by the heater.
7
Part-turn actuators SG 03.3 – SG 04.3
Operation instructions
with AUMATIC AC 01.1
Service data
– Service phone
– Internet address
– Service text
Monitoring and safety
functions
– Monitoring of the motor temperature (motor protection)
– Reaction monitoring (programmable)
3)
– Operating time (programmable)
– Max. running time per hour (programmable)
– Max. cycles per hour (programmable)
– Internal diagnosis:
- Control of motor controls
- Sub-assembly monitoring
Profibus DP interface (option)
Profibus DP according to EN 50170
– 2 analogue and 4 digital customer inputs, internal supply (24 V DC/max.
100 mA) via power supply unit of the AUMATIC possible (see "voltage output")
– Programmable process representation
– Profibus DP (V1) (option)
– Fibre optic connection (option)
– Redundant fibre optic connection (option)
– Overvoltage protection (option)
– Redundancy: 2 separate bus interfaces in the AUMATIC (option)
For complete description see "Technical data actuator controls AUMATIC with
Profibus DP interface".
Modbus interface (option)
– 2 analogue and 4 digital customer inputs, internal supply (24 V DC/max.
100 mA) via power supply unit of the AUMATIC possible (see "voltage output")
– Overvoltage protection (option)
– Redundancy: 2 separate bus interfaces in the AUMATIC (option)
– For complete description see "Technical data actuator controls AUMATIC with
Modbus interface".
Setting/programming
– Via menu and the push buttons and display of the local controls
(password-protected)
– Via the programming software COM-AC (option)
– Illuminated LC display, 4 lines with 20 characters each, plain text display
Local controls
– Selector switch LOCAL-OFF-REMOTE, lockable
– Push buttons OPEN-STOP-CLOSE-RESET
– Illuminated LC display, 4 lines with 20 characters each, plain text display
– Indication lights (programmable):
Standard configuration:
End position CLOSED (yellow), torque fault CLOSE
5)
(red), motor protection
tripped (red), torque fault OPEN
5)
(red), end position OPEN (green)
– Running indication: Blinking indication lights OPEN/CLOSE
Ambient temperature
Refer to Technical Data Part-turn actuator
Enclosure protection acc. to EN 60529
Standard IP 67; Option: IP 68
3) Requires position transmitter (potentiometer or RWG) in actuator.
5) Not available
