AudioCodes MP-26 series, User Manual

Page: 110 / 464

User's Manual 110 Document #: LTRT-23510
MP-26x/MP-27x Multimedia Home Gateway
Parameter Description
Media Server Address
The address of the remote media server that handles conference calls.
Note: This parameter is available only when ‘Remote’ is selected for the
parameter '3 Way Conference Mode'.
Message Waiting Indication
Enabled If a user has an unheard voice mail message, a stutter dial tone is heard
when the user picks up the phone. In addition, the device generates an
FSK signal to the phone to indicate that a message is waiting. If the
telephone connected to the device supports this feature, an MWI ‘envelope
icon’ is displayed.
Subscribe to MWI
Select this check box if you must register with a MWI subscriber server. If
so, configure the three parameters below.
MWI Server IP Address
or Host Name Defines the IP address or host name of the MWI server.
Note: This parameter is available only when the check box 'Subscribe to
MWI' is selected.
MWI Server Port
Defines the port number of the MWI server.
Note: This parameter is available only when the check box 'Subscribe to
MWI' is selected.
MWI Subscribe
Expiration Time Defines the interval between registrations.
Note: This parameter is available only when the check box 'Subscribe to
MWI' is selected.
Auto Attendant
Enabled Enables/Disables the Auto Attendant feature.
Line Enables line numbers as they appear in the Line Settings tab.
Input Timeout Enables the time in seconds, from the beginning of the Auto Attendant
message, until the conversation disconnects, if the user hasn’t received
any input. This field should be set to the length of the Auto Attendant
message itself, plus a few seconds to allow the user to press the required
extension or to repeat the message.
Greeting File Defines the file name of the Auto Attendant message (.pcm), recorded in
Section
9.5.1.1 .
General Parameters
Stutter Tone Duration When you enable message waiting and an unheard message exists, a
stutter tone is played to the phone for the duration configured by this
parameter and/or when you activate the call forwarding feature (see
Section
10.5 on page 134 ).
Out of Service Behavior Defines the tone which is played instead of a dial tone if the user
configured a registrar IP and the registration failed. When the Reorder tone
is selected, a Reorder tone is played instead of a dial tone. If “No Tone” is
selected, then no tone is played.