AudioCodes MediaPack MP-112, User Manual

Page: 462 / 622

User's Manual 462 Document #: LTRT-65417
MP-11x & MP-124
Parameter Description
[802. 1xUsername] empty string.
Web: 802.1x Password
EMS: Password
[802. 1xPassword]
Defines the password for IEEE 802.1x support.
The valid value is a string of up to 32 characters. The default is an
empty string.
Web: 802.1x Verify Peer
Certificate
EMS: Verify Peer Certificate
[802. 1xVerifyPeerCertificate]
Determines whether the device verifies the Peer Certificate for IEEE
802.1x support.

[0] Disable (default)

[1] Enable
43.1.2 Multiple VoIP Network Interfaces and VLAN Parameters
The IP network interfaces and VLAN parameters are described in the table below.
Table 43-2: IP Network Interfaces and VLAN Parameters
Parameter Description
Multiple Interface Table
Web: Multiple Interface Table
EMS: IP Interface Settings
[InterfaceTable]
This table parameter configures the Multiple Interface table. The
format of this parameter is as follows:
[InterfaceTable]
FORMAT InterfaceTable_Index =
InterfaceTable_ApplicationTypes,
InterfaceTable_InterfaceMode, InterfaceTable_IPAddress,
InterfaceTable_PrefixLength, InterfaceTable_Gateway,
InterfaceTable_VlanID, InterfaceTable_InterfaceName,
InterfaceTable_PrimaryDNSServerIPAddress,
InterfaceTable_SecondaryDNSServerIPAddress,
InterfaceTable_UnderlyingInterface;
[\InterfaceTable]
For example:
InterfaceTable 0 = 0, 0, 192.168.85.14, 16, 0.0.0.0, 1,
Management;
InterfaceTable 1 = 2, 0, 200.200.85.14, 24, 0.0.0.0, 200,
Control;
InterfaceTable 2 = 1, 0, 211.211.85.14, 24, 211.211.85.1, 211,
Media;
The above example, configures three network interfaces
(OAMP, Control, and Media).
Notes:

For this parameter to take effect, a device reset is required.

For a description of this parameter, see 'Configuring IP
Network Interfaces' on page
105 .
Single IP Network Parameters
Web: IP Address
EMS: Local IP Address
[LocalOAMIPAddress]
Defines the device's source IP address of the operations,
administration, maintenance, and provisioning (OAMP) interface
when operating in a single interface scenario without a Multiple
Interface table.
The default value is 0.0.0.0.
Note: For this parameter to take effect, a device reset is
required.