AudioCodes MediaPack MP-112, User Manual

Page: 396 / 622

User's Manual 396 Document #: LTRT-65417
MP-11x & MP-124
Parameter Description
Maximum Channels for Session
[Test_Call_MaxChannels]
Defines the maximum number of concurrent channels for the test
session. For example, if you have configured an endpoint "101"
and you set this parameter to "3", the device automatically creates
three simulated endpoints - "101", "102" and "103" (i.e.,
consecutive endpoint URIs are assigned).
The default is 1.
Call Duration
[Test_Call_CallDuration]
Defines the call duration (in seconds).
The valid value is -1 to 100000. The default is 20. A value of 0
means infinite. A value of -1 means that the parameter value is
automatically calculated according to the values of the 'Calls Per
Second' and 'Maximum Channels for Session' parameters.
Calls Per Second
[Test_Call_CallsPerSecond]
Defines the number of calls per second.
Test Mode
[Test_Call_TestMode]
Defines the test session mode.

[0] Once = (Default) The test runs until the lowest value
between the following is reached:

Maximum channels is reached for the test session,
configured by 'Maximum Channels for Session'.

Call duration ('Calls Per Second') multiplied by calls per
second ('Calls Per Second').

Test duration expires, configured by 'Test Duration'.

[1] Continuous = The test runs until the configured test
duration is reached. If it reaches the maximum channels
configured for the test session (in the 'Maximum Channels for
Session'), it waits until the configured call duration of a
currently established tested call expires before making the next
test call. In this way, the test session stays within the
configured maximum channels.
Test Duration
[Test_Call_TestDuration]
Defines the test duration (in minutes).
The valid value is 0 to 100000. The default is 0 (i.e., unlimited).
Schedule Interval
[Test_Call_ScheduleInterval]
Defines the interval (in minutes) between automatic outgoing test
calls.
The valid value range is 0 to 100000. The default is 0 (i.e.,
scheduling is disabled).
40.1.1 Starting and Stopping Test Calls
The procedure below describes how to start and stop test calls.

To start and stop a test call:
1. In the Test Call table, select the required test call entry; the Actions button appears
above the table.
2. From the Actions drop-down list, choose the required command:
•
Dial to start the test call
•
Drop Call to stop the test call