
Doors and windows
with the 3rd step, or try holding the trans
mitter nearer or further away from the radia
tor grille.
9. If the garage door or other system still fails
to be activated using the buttons in the head
liner after programming is completed, it is
possible that the system might be working
with a rolling code instead of the normal
fixed security code. If this is the case, a
roll
ing code programming
is required in addi
tion to the steps described above
¢page 36.
Follow the instructions above to program the
other two buttons in the headliner. Start with the
3rd step.
Erasing the button programming
Programmed buttons can only be erased all at
once; it is not possible to erase them individually.
Reprogram the buttons if necessary.
.. Switch on the ignition.
.. Press and hold down the two outer buttons in
the headliner until the yellow LED
@
goes out
and the green LED
@
lights up.
Reprogramming the buttons
.. Switch on the ignition.
.. To reprogram an individual button, press and
hold the desired button until the LED
@
begins
to flash rapidly (after about 20 seconds). Then
release the button immediately. The program
ming mode is then activated for 5 minutes.
.. Continue with the 5th step.
@
Note
- The required distance between the hand
held transmitter and the HomeLink module
inside the radiator grille¢
Fig. 34
depends
on the system you are programming.
- With some types of systems, you may need
to briefly release the button during pro
gramming and then press it again. When
programming a new device, keep the button
pressed for at least 15 seconds before try
ing again with the transmitter in a different
position. Watch out for your vehicles's haz
ard light signals during that time.
36
Rolling code programming
Applies to vehicles: with garage door opener (Homelink)
Some
devices require rolling
code
programming.
Identifying a rolling code
.. Press a programmed button in the headliner
again and hold it down.
.. Watch the LED
@
¢
page
35, Fig. 33.
If the
LED starts flashing rapidly, this indicates that
the system you wish to operate, such as a ga
rage door, is equipped with a rolling code.
.. Program the rolling code as follows:
Activating a system's drive unit
.. Locate the programming button on the sys
tem's drive unit. The exact location and colour
of the button may vary depending on the type
of system.
.. Press the programming button on the system's
drive unit (this will normally cause an indicator
lamp on the unit to light up). You now have
about
30 seconds
to start and complete the
programming process for the button in the
headliner.
Programming the button in the headliner
.. Press the previously programmed button in the
headliner for 2 seconds .
.. Press the button for 2 seconds again to com
plete rolling code programming.
.. For some systems, the button may have to be
pressed a third time to complete the program
ming sequence .
After programming, the system should recognise
the signal and respond when the button in the
headliner is pressed. Now the other control but
tons can be programmed as required.
ijJ)
Note
- Having a second person assist you makes
programming of the rolling code easier and
faster.
- If you encounter problems programming
the rolling code you may find helpful infor
mation in the operating instructions of the
system you wish to operate.