Attacus FireFly AP1000, Manual

Page: 11 / 44

7
FireFly Training & Indoor Cycling
Attention !
⚫
Please follow the instructions for assembly to ensure all the components are all set
and tightened. Fail to follow the correct steps may cause damage to the equipment
and make unsettling noises. Using equipment that is improperly assembled may
lead to serious injury and death.
⚫
If you have any question or the equipment has any missing parts, please contact
your distributor or dial in the customer service number on the maintenance card.
⚫
The equipment should be assembled by a least 2 persons. Do no attempt to pull up
the bike with single arm because some parts can be heavy. Assembling alone may
lead to serious injury and damage to the equipment when parts are dropped.
⚫
When the product arrived, please carry it carefully. Place the carton box on a flat
surface. Do not open the box when it is placed on its side to prevent parts from
falling out.
⚫
It is highly recommended for you to place a mat on the floor to protect your
flooring.
⚫
Please unpack and assemble the product on a set location to reduce unnecessary
moving.
⚫
Please be careful when removing the cable ties on the package exterior. The cable
ties outside the box may produce strong momentum; it might bounce off and snap
on the people around if not cautiously removed.
⚫
When unpacked, please place all the components in a clear area to enhance the
assembling process.
⚫
Please follow the proper instructions. When performing each step, please be sure
all the screws and bolts are in place and partially tighten. Please tighten all the
screws and bolts when all are in place.
⚫
Please be sure all the loose components are fixed and tightened. Please do not
reduce the number of screws and/or bolts used to prevent unwanted danger and
harm.
⚫
Some parts are pre-lubricated to help with the assembly. Do not wipe off the
grease. If you have encountered difficulty when assembling, you can apply some
grease when assembling. It is recommended to use lithium-based grease.
⚫
Unauthorized personnel are prohibited to remove the maintenance covers.
⚫
Before the assembly is completed, do not throw away the packaging material.