84
32099DS–06/2010
AT32UC3L016/32/64
11. Datasheet Revision History
Please note that the referring page numbers in this section are referred to this document. The
referring revision in this section are referring to the document revision.
11.1
Rev. D - 06/2010
11.2
Rev. C - 06/2010
11.3
Rev. B - 05/2010
1.
Ordering Information: Ordering code for TQFP ES changed from AT32UC3L064-AUES to
AT32UC3L064-AUTES. TLLGA48 Tray option added.
1.
Features and Description: Added QTouch library support.
2.
USART: Description of unimplemented features removed.
3.
Electrical Characteristics: Power Consumption numbers updated. Flash timing numbers
added.
1.
Package and Pinout: Added pinout figure for TLLGA48 package.
2.
Package and Pinout, GPIO function multiplexing:TWIMS0-TWCK on PA20 removed. ADCIFB-
AD[3] on PA17 removed, number of ADC channels are 8, not 9.
3.
I/O Lines Considerations: Added: Following pins have high-drive capability: PA02, PA06,
PA08, PA09, and PB01.
Some TWI0 pins are SMBUS compliant (PA21, PB04, PB05).
4.
HMATRIX Masters: PDCA is master 4, not master 3. SAU is master 3, not master 4.
5.
SAU: IDLE bit added in the Status Register.
6.
PDCA: Number of PDCA performance monitors is device dependent.
7.
Peripheral Event System: Chapter updated.
8.
PM: Bits in RCAUSE registers removed and renamed (JTAGHARD and AWIREHARD renamed
to JTAG and AWIRE respectively, JTAG and AWIRE removed. BOD33 bit removed).
9.
PM: RCAUSE.BOD33 bit removed. SM33 reset will be detected as a POR reset.
10.
PM: WDT can be used as wake-up source if WDT is clocked from 32KHz oscillator.
11.
PM: Entering Shutdown mode description updated.
12.
SCIF: DFLL output frequency is 40-150MHz, not 20-150MHz or 30-150MHz.
13.
SCIF: Temperature sensor is connected to ADC channel 9, not 7.
14.
SCIF: Updated the oscillator connection figure for OSC0
15.
GPIO: Removed unimplemented features (pull-down, buskeeper, drive strength, slew rate,
schmitt trigger, open drain).
