AT-OME-MS42
68
1.
Connect a serial cable from the
RS-232
port on the AT-OME-MS42, to the RS-232 port on the display.
The included 3-pin captive screw connector should be wired as shown.
Using RS-232
2.
Login to the web server. Refer to
Introduction to the Web Server (page 51)
.
3. Click
A/V Settings
in the menu bar.
4. Verify that the
Switching Mode
is set to
Mirrored
. Display control is
not
supported under
Matrix Mode
.
DP
HDMI 3
HDMI 4
PWR
LINK
USB-C
HDBaseT OUT
AT-OME-MS42
OMEGA
TM
MULTI-FOMAT SWITCHER
IP MODE
DP
HDMI 3
HDMI 4
USB-C
HDMI OUT
HDMI IN
1
2
1
2
3
4
DP IN
USB-C IN
HDMI OUT
HDBaseT OUT
LAN
DC 24V
RESET
AUDIO OUT
USB HOST
RS-232
L
R
RX TX
+
+
USB
USB
USB HUB
Display
AT-OME-MS42
GND
GND
RxD
TxD
TxD
RxD
to display
Solution Setup and Configuration Guide
5. Click
RS-232
in the menu bar.
6. Set the RS-232 settings for the display (sink) device, under the
RS232 Console
section. These settings must
match the device settings for the display. Refer to the User Manual of the display device for more information.
