- 13 -
Operating Manual SunSpray for SUNTEST
®
XLS+
3.6 Installation and space requirements
Weight of the instrument:
• SUNTEST
®
XLS+
approx. 90 kg
• SUNTEST XLS+ and SunSpray (empty) approx. 112 kg
• SUNTEST XLS+ and SunSpray (full)
approx. 160 kg
CAUTION – possible bodily injuries!
To place the SUNTEST XLS+ on the SunSpray, the
SUNTEST XLS+ must be held by the four handles
mounted into the sides of the unit. Otherwise there is
a danger of damaging the cover plate of the SunSpray!
Wear protective gloves for all installation work!
NOTE – load at the installation site
If several instruments are installed in one place, the static
load capacity of the installation site must be ensured.
NOTE – gripping points on the SUNTEST XLS+
The SUNTEST XLS+ may only be held and lifted with the
handles mounted into the sides of the unit.
Installing the device (fig. 1):
Stand the SunSpray either on the floor or on a stable,
non-flammable laboratory table and align horizontally.
Place the SUNTEST XLS+ on the SunSpray:
Lift the SUNTEST XLS+
1
by the handles
2
and place
on the SunSpray
3
, fit the rubber feet over the two (see
arrow in drawing) fixing points on the cover of the Sun
-
Spray. The two fixing points on the cover serve to position
the SUNTEST XLS+ on the accessory.
Space requirements:
Pay attention to leave sufficient space for accessing the
maintenance hatch
9
(see
fig. 4.1
, page 14) and the wall:
Distance from the wall:
at least 50 cm
Distance at side:
at least 50 cm
3
Requirements for installation
1
2
3
Fig. 1