L* 0.2 = D
this applies to the use of long work cycle air line
tools. A single point lubricator type Atlas Copco
Dosol can also be used for tools with short running
cycles.
Information about Dosol settings may be found
under Air Line Accessories in our main catalogue.
Lubrication-free models:
• In the case of lubrication-free tools it is up to the
customer to decide on the peripheral equipment
to be used. However, it is no disadvantage if the
compressed air contains a small quantity of oil
e.g. supplied from a fog lubricator (DIM) or Dosol
system. This does not apply to turbine tools, which
should be kept oil free.
Compressed air connection
• The machine is designed for a working pressure
of 6–7 bar = 600–700 kPa = 87–102 psi.
• Blow out the hose before connecting.
Installation proposal
Choosing the correct couplings, hose and clamps can
be a troublesome digging into details. To save your
time and to ensure correct capacity of the airline in-
stallation, from the tapping point to the tool, we offer
you an installation proposal.
ERGONIP 10
5 m RUBAIR 10
8202 1180 44
8202 1180 20
ERGONIP 10 0.7 m RUBAIR 10
NIPPLE
Male 3/8" BSPT
ERGOQIC 10
BALL VALVE +
MIDI F/RD 15 +
ERGOQIC 10
8202 0829 11
ip03_1
For more information please read, Atlas Copco In-
dustrial Power Tools catalogue Ordering No. 9837
3000 01.
Handling
Operation
c
2
1
j
5000080
Feed force
To get full power out of the tool a feed force must
be applied to bring the mechanism into the middle
of its free travel in the handle.
Too high feed force results in reduced vibration
damping, without increasing the material removal,
as the cylinder will hit the bottom in the handle.
The standard recoil spring (33) is designed for
best vibration damping and control of the chipping
process in most applications, see fig.
The enclosed alternative recoil spring (33a), with
yellow paint marking, is softer than the standard
spring. If the tool is going to be used in a light applic-
ation where standard spring may be too hard, please
mount the alternative spring according to the en-
closed instruction. Test the tool in your application
and chose the spring that works best.
© Atlas Copco Industrial Technique AB - 9836 5546 00
6
RRF 31
EN
Safety and operating instructions
