Atlantis Land I-Storm A02-RA, Command Reference Manual

Page: 55 / 112

ppp 2 remoteip 192.168.200.2
ppp 2 enable
(and the corresponding setup for each of the channels 3 to 8 as well)
Clients can now dial in to this server, be allocated IP addresses and traffic will be
sent to and from the router.
8.2.4 Remote Bridging
To create a system where two bridges are connected by a PVC, do the following at
each end: (In this example, interface 2 is attached to the bridge in ATMOS (interface
1 is reserved for routed traffic).)
bridge device add ppp/DEVICE=2
(Attach interface 2 to the bridge.)
ppp 1 pvc 32 mac
ppp 1 interface 2
ppp 1 enable
If required, multiple interfaces can be attached to the bridge of a single ATMOS
system so that a single
master site is bridged to several satellites. Each incoming
bridging PPP channel should be attached to a distinct interface. Each interface must
be independently attached to the bridge.
8.3 <channel> clear
8.3.1 Syntax
<channel> clear
8.3.2 Description
Clear all aspects of this channel back to their default settings. If there is an active
connection, it is torn down.
8.4 <channel> disable
8.4.1 Syntax
<channel> disable
8.4.2 Description
Clear the enable flag for a PPP channel. This is the default setting. Disabling does
not remove other configured information about this channel.
In the PPP state machine, this sets the PPP link to
close d. If it is already closed, there
is no effect.
Configuration saving saves this information. By default, all channels are disabled.
8.5 <channel> discard