www.atestgaz.pl
The entered muting time is accepted by depressing the
button and then the new timing parameter
can be entered. Upon the last parameter is set up, all timings are stored into the controller memory.
3.8.6
Gateway settings
Authorization level required for the operation
2 – Maintenance staff
Specification
Makes it possible to change parameters of the built-in gateway
(GTW)
Upon the option is selected, the request is displayed to enter operation parameters for the internal data
gateway (GTW).
Subsequent screens are dedicated to the following parameters:
1.
Data transmission protocol.
2.
Network address.
3.
Transmission rate
4.
Parity check standard
5.
Frame format (refers only to the MODBUS ASCII protocol).
See details in Section 2.4.
The entered parameter is accepted by depressing the
button and automatically a window with the
next parameter is displayed. Upon the last parameter is entered, all settings are stored into the controller
memory.
3.8.7
Logout
See section 3.7.8.
3.9
Results of operations
Some options available in the menu of the Control Unit Module needs execution of any operation, such as
readouts or writing a configuration memory of gas detectors or an operation can be carried out upon a
command sent by the control unit. If so, the display shows some messages associated with execution of
these operations. For instance:
Upon the operation is completed, the Control Unit Module shows its results. When the operation is
successfully completed the following message is displayed (content of the top line depends on the specific
operation):
However, if something goes wrong the message with an error code is shown:
s. 34|40
User Manual: POD-003-ENG R04
Memory readout
...
Noise gate
- error (code X)
Noise gate
- passed
Protocol
MODBUS ASCII
Summary of Contents for PW-033-B
Page 1: ...POD 003 ENG R04 User Manual Control Unit Module Sigma MOD LCD Product code PW 033 B...
Page 49: ...www atestgaz pl Notes...
Page 50: ...www atestgaz pl Notes...
Page 51: ......
