Chapter 2. Hardware Setup
9
Installation
To set up your PE4104G installation, refer to the numbered steps in the
installation diagram below (the numbers in the diagram correspond to the
numbered steps), and do the following:
1. Ground the PE4104G by connecting one end of a grounding wire to the
Grounding Terminal and the other end to a suitable grounded object.
Note:
Do not omit this step. Proper grounding helps to prevent damage to
the unit from power surges or static electricity.
2. For each device you want to connect, connect its power cable to any
available outlet on the unit. Optionally, use ATEN Lok-U-Plug cable
holders to secure them. See
3. Connect an internet-enabled LAN cable into the unit’s LAN Port.
4. (Optional) If you are to use an environmental sensor in your installation,
connect it to the RJ-11 Sensor Port located on the unit’s front panel.
5. (Optional) If you are to use a door sensor in your installation, connect it to
the Door Sensor Dry-Contact Port located on the unit’s front panel.
6. Use the provided Power Cord to connect the unit’s Power Inlet Socket to
an AC power source.
7. Once you have finished these installation steps, you can turn on the
connected devices.
1
6
Rear
2
3
4
Front
5
