Astralpool Viron Connect 10, Installation And Operating Instructions Manual

Page: 61 / 76

61
Internet Gateway for security reasons. This will be required to register the Internet
Gateway onto the internet and needs to be retained by the pool owner.
The Internet Gateway needs to be installed in a position where it can be connected by a
RJ12 cable to the pool system and also to the internet. The RJ12 cable for the Internet
Gateway can be connected to the Connect 10 controller or to the Touchscreen. (This also
applies when the Touchscreen is connected to the Connect 10 via RF Transceivers 10016 &
10017).
The home Wi-­‐Fi signal strength can initially be observed using a mobile phone as a guide. As
a reliable connection is essential, it is important to find a position that has a strong Wi-­‐Fi
signal as well as access to the pool systems RJ12 connections. The Internet gateway has a
reset button in its base, as well as LED’s that will assist with service fault finding, so these
should also be considered when determining the position.
Once an approximate position is determined, the Internet Gateway can be connected to a
loose RJ12 cable so that the true signal strength can be determined prior to final mounting.
Base (underneath) of Internet Gateway
After connecting the Internet Gateway to the Pool System the Home Wi-­‐Fi can be
configured.
This is achieved using the Touch Screen
1. On the Touchscreen, go to ‘Setup’.
Connected
Wifi
Alive
Reset switch
RJ12
To Pool
System
RJ45
To Ethernet