Astralpool Viron Connect 10, Installation And Operating Instructions Manual

Page: 14 / 76

14
k. Repeat above process for each additional timer period required.
Note: It is important that timer periods do not overlap each other as this may result in intermittent or
erratic operation of your equipment. Once all timer periods are set, observe start and finish times for each
and ensure no overlap occurs.
l. The final timer period (if configured in your setup) is for “Heat Demand”. This feature allows
you to bring your filtration or heating pump on each hour to sample the water temperature
of your pool or spa. If the temperature is below the set point, the pump will continue to
operate until the desired temperature is achieved then it will switch off. To program heat
demand;
i. Go to the bottom of the timer list and find Heat Demand. Touch on the word
“Disabled”.