7-2
SORGENTE/SMILE/ISI-T/UNDERCOUNTER - Installation, Use and Maintenance - cod. A-MAN03 - Rev. 02/2012
7.1.1
List of signallings
A1: exhausted filter pre-alarm.
It indicates phase that precedes the machine blockage
because of exhausted filter
(about 30 days before the
machine blockage). The red Led 1 on the left key (room
temperature water dispensing) starts to blink and it is
followed by 2 beeps every 15 seconds; moreover, every time
the dispensing keys are pressed the 2 beep are repeated.
A4: refrigeratr alarm.
If for technical reasons or for possible clogging in the
heating exchanger,
the cooling system should not reach
the pre-set temperature in 6 hours
, the cooling system
must be switched off and the water dispensing interrupted.
In this case, will appear a fixed red Led 2 positioned above
the right key, (cold water dispensing) followed by 7 beep
every 15 seconds; moreover, every time the dispensing
keys are pressed the 7 beep are repeated.
B1: exhausted filter blockage.
This function follows the filter pre-alarm A1.
The machine
is blocked when the filter is completely exhausted
.
In this case, the red Led 1 above the left dispensing key
(room temperature water dispensing) starts to blink and
it is followed by a 15 seconds long beep which will be
repeated each time the dispensing keys are pressed.
The
machine could be restarted only by replacing the filter
and inserting the smart card, supplied with the new
filter, in the proper fissure, see paragraph 8.3.
B2: pump blockage.
In case the pump is not able to restore the water level in
the carbonator in 3 minutes,
the pump is blocked to avoid
any damages
. In this phase will appear a fixed red Led
2 on the right, positioned above the right key (cold still
water dispensing), followed by 6 beep every 15 seconds.
E00: smart card wrong insertion error.
The machine will not accept the smart card put in a wrong
way. By inserting the smart card, in the right way, a 5
long beep will be heard and OK will appear on the display.
Then take out the smart card.
E02 and E12: smart card error.
This error occurs when an unloaded or damaged smart
card is inserted or if it contains data not related to the
device.
fig.7.3
Led 2
Led 1
Led 2
Led 1
