4-3
SORGENTE/SMILE/ISI-T/UNDERCOUNTER - Installation, User and Maintenance - cod. A-MAN03 - Rev. 02/2012
4.4 Presassembly ISI-T
To avoid damage during transport model ISI-T is packed
with some components not fully assembled: must be
correctly placed the drip tray, bracket, front splash guard
and the protective cover of the dispensing point.
Furthermore, it is required to connect the pipe of the
hydraulic internal circuit to the point of dispense and
connect the two wires.
ATTENTION: In models equipped with
Ozone Sanitation (optional) you must
also connect the red pipe on the front
point of dispense, as shown in photo at
left, being careful not to choke the pipe.
Before proceeding to the next section “Installation and
First Start”, we require you to:
• position the bracket splash guard on the front panel,
taking care to let out of the upper front hole the water
pipe with the green fitting;
• insert on the back of the upper front hole one of
the two clamping flanges, and screw on the bracket
splash guard;
• insert on the back of the lower front hole one of
the two clamping flanges, and screw on the bracket
splash guard;
• connect the two electrical wiring placed on the back
of the top hole;
• remove the point of dispense from its seat to be able
to more easily insert the pipe with the green fitting;
• connecting the pipe with the fitting of green color to
the dispensing point by inserting it inside the seat and
by turning the green ring nut counterclockwise (Note:
for model provided with optional Ozone Sanitizing we
require you to also connect the red silicone pipe on
the point of dispense, being careful not to choke it);
• relocate the point of dispense;
• place the protective cover;
• insert the drip tray.