47
Cooker Support Bracket
• After installing and leveling the appliance using the
adjustable legs, use a pencil to mark a line on the
fl
oor in front of the appliance (marking the lower
edge of the appliance front panel) and determine the
middle of the appliance.
• Then add a marking 60 mm to the left and 60 mm
to the right of the center and remove the appliance
(Figure 1).
• Mark the point that is located 397 mm from the center
marking on the line marked on the
fl
oor (position of
hole No. 1), perpendicularly to the line, towards the
back of the appliance; from there, mark the point
located 40 mm further in the same direction (± 0,1
mm) (position of hole No. 2).
• At the marked spots, drill two holes in the
fl
oor and
insert the plastic dowels supplied. Adjust the height
of the support bracket as necessary and
fi
x the two
parts of the bracket by tightening the two screws.
Then, screw the bracket into the holes drilled in the
fl
oor (Figure 2).
• Push the appliance back into its original position.
• Remove the appliance drawer (see section
“Appliance Drawer”) and insert the screw into the
bracket from the inside (Figure 3).
NOTE: If the supplied screws and dowels are inadequate
to securely
fi
x the bracket to the
fl
oor, please obtain
appropriate hardware for securing the bracket in such
way that it cannot be pulled out.
