42
b)
• Slightly lift the supports on the left and right side of
the door (marking 1 on the support) and pull them
away from the glass (marking 2 on the support) (see
Figure 1).
Figure 1
1
2
• Hold the door glass by the lower edge, slightly lift it
so that it is no longer attached to the support, and
remove it (Figure 2).
Figure 2
• To remove the third inside glass (only with some
models), lift and remove it. Also remove the rubbers
on the glass (Figure 3).
Figure 3
• To replace the door, observe the reverse order.
NOTE!
Note: To replace the glass, make sure the
markings (crescent) on the door and the glass
are aligned (Figure 4).
Figure 4
Removing and replacing the oven door with a cam
hinge
• Completely open the oven door. Lift the clips of the
lower hinge supports on both sides to the upright
position and clip them to the plug of the upper hinge
supports.
• Close the oven door half way and gently pull them
out. Replace the door in the reverse order.
• Insert the door in the half
-
closed position (angle of
approximately 60°) by pushing them towards the
oven while opening them all the way. Pay attention
to the notches on the lower hinge supports, which
should coincide with the lower edge of the notches on
the front side. When the door is completely opened,
remove the clips from the plugs of the upper hinge
supports and return them to horizontal position.
REMOVING AND REPLACING THE OVEN DOOR
WITH A SINGLE-AXIS HINGE
GentleClose
– the system absorbs the shock from
door closing. It allows simple, quiet, and smooth closing.
A gentle push (to a 15° angle relative to the closed door
position) is enough for the door to close automatically
and softly.
NOTE!
If the force applied to close the door is too strong,
the e
ff
ect of the GentleClose system is reduced or
the system will be bypassed for safety.
• With
GentleClose
door system, rotate the stoppers
back by 90°(Figure 2).
fi
gure 2
