54
When the lamp isn’t illuminated, it may indicate that the lamp has been damaged.
When you replace the lamp in a projector installed on the ceiling, you should stand beside the lamp
cover other than under it; for the broken glass may fall down to hurt you. To do that, remove the
lamp cover gently to avoid being hurt by the dropped glass. If glass drops into your eyes or mouth,
you should see the doctor immediately.
CAUTION
CAUTION
CAUTION
Screws
Screws
Lamp cover
Lamp 2
Lamp 1 Handle
Maintenance and cleaning
Replace the lamp
When the projection lamp of the projector
reaches its end of life,the Lamp replacement
icon appears on the screen and LAMP
indicator flashes yellow. Replace the lamp with
a new one of the same type promptly. The
timing when the LAMP indicator should light is
depending on the lamp mode.
Indicator
When the projection lamps reaches its end of
life, LAMP indicator flashes yellow.
݁സ४
Lamp Replacement
Lamp Replacement icon
As temperature inside the projector is
high, you should cool the projector for
at least 45 minutes before you open the
lamp cover.
For the sake of safety, only use the lamp
of the same model. Never drop the lamp
onto the ground nor touch the glass bulb!
The glass can shatter and hurt.
To replace the lamp, follow the steps below:
1. Power off the projector and unplug the
power cord. Then let the project cool for at
least 45 minutes.
2. Loosen the screws on the lamp cover and
open the cover.
3. Loosen the screws on the lamp 1, hold the
handle and remove out the lamp 1.
4. Remove out the lamp 2 with the same way
of step 3.
5. Install new lamps with the same model and
tighten the screws. Make sure the
installation is correct. Put lamp cover in
place and then tighten the screws.
6. Plug the AC power cord and power on the
projector.