43
3D mode
This function is used to open or close the 3D mode.
On........Open the 3D mode.
Off........Close the 3D mode.
Setting
Cooling fast
This function provides the following options in the cooling fans’ operation after turning off the
projector.
Normal... Normal operation.
60s ........ Faster and lounder than Normal, cooling time is shorter.
When 3D mode is set on, press 3D button on the remote control to display the 3D menu, then
you can set the 3D format and 3D display.
3D Format
3D Display
DLP link
IR
Exit 3D mode
SW Version
Disable 3D
L/R eye flip
Side by side half resolution
Side by side full resolution
Field sequential
Frame sequential
Top/Botton half resolution
Top/Botton full resolution
Manual configuration page
3D Format
3D Display
3D display:
DLP link...........When using infrared DLP link glasses, select
this option.
IR.................... When using an infrared 3D glasses, select
this option.
Exit 3D mode ..quit 3D mode.
SW Version......Display the current software version.
3D Format:
Disable 3D
...............
3D function is disable.
L/R eye flip...........................Flip the right and left frame.
Side by side half resolution..in this format each input source
frame will consist of two horizontally
packed frames at half number of
pixels each.
Side by side full resolution...in this format input source frame will
consist of two horizontally packed
frames at full number of pixels each.
Field sequential....................in this format each left and right frame has half the lines.
Frame sequential.................in this format each left and right frame has full lines.
Top/Bottom half resolution...in this format each input source frame will consist of two vertically
packed frames at half number of lines each.
Top/Bottom full resolution.....in this format input source frame will consist of two vertically
packed frames at full number of lines each, plus an Active Blank
Space between the vertical frames.
Manual configuration page...Enter manual configuration page to configure the paramters
below and save the configuration: Formart, LR reference, Frame
domiance, LR encoding, TB reference, OE reference, Active blank
lines, Encoded lines, Left encoded line location, Right encoded
line location and Blanking color.
Note:
This function is enable only for DVI, display Port, HDMI1,HDMI2 and HDMI3 input source.
