12
Remote Control Code
30°
30°
30°
30°
30°
30°
30°
30°
5m
5m
5m
5m
TERMINAL
TERMINAL
OK
Numbers
LED indictaor
Press and hold the
OK and any number
button (0-9) for more
than five seconds to
switch among Code 0
~ Code 9.
LED indictor on the
remote control will flash
twice after the code is
successfully set.
Remote control
Part names and functions
Install remote control batteries
①
Open the battery
compartment lid.
②
Install new batteries
into the compartment.
③
Replace the
compartment lid.
Two AAA batteries
For correct polarity
(+ and –), be sure
battery terminals
are in contact
with pins in the
compartment.
To ensure safe operation, please observe the following precautions:
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid matter.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and
install new batteries.
● Risk of explosion if a battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions on the battery or local
regulations or guides.
Remote Control operating range
Point the remote control toward the projector
remote receiver (front, back left and right)
when pressing any button.
The maximum operating range for the remote
control is about 5 meters and 60 degrees.
The ten different remote control codes (Code
0 - Code 9) are assigned to this projector.
Switching the remote control codes prevents
interference from other remote controls
when several projectors or video equipment
next to each other are operated at the same
time. Change the remote control code for the
projector first before changing that for the
remote control. See "Remote control" in the
Setting Menu on page 48.
Press and hold the OK and any number button
(0-9) for more than five seconds to switch
among Code 0 ~ Code 9.
The initial code is set to Code 0.