Setting Up the MultiVoice Gateway Hardware
Starting up the MultiVoice Gateway
MultiVoice Gateway for the MAX— User’s Guide
Preliminary November 23, 1998
3-13
Starting up the MultiVoice Gateway
To start up the MultiVoice Gateway, perform the following steps:
1
If you are using a PC, configure the terminal-emulation function in your communications
software as follows:
–
9600 bps
–
8 data bits
–
No parity
–
1 stop bit
–
Direct connect
2
Make sure that you can see the LEDs on the front panel of the MultiVoice Gateway while
you view the VT100 display.
3
Connect one end of the AC power cord to a power source and the other end to the
MultiVoice Gateway.
The power-on self-test (POST) begins and finishes within one minute.
4
While the POST is running, watch the LEDs.
If the Power LED is on and the Fault LED is off, the MultiVoice Gateway is operating
properly. You can continue with the next step.
If either the Power LED is off or the Fault LED is on, remove the power cord and do not
continue. Contact your Ascend distributor
5
Watch the VT100 display during the POST. When the POST is successful, the following
screen appears:
6
Press any key. The following reminder screen appears, instructing you to edit your line
configuration before you dial:
Edit Line Config
before dialing
Press any key...
Press any key again to display the MultiVoice Gateway Main Edit menu as shown.
|------------- EDIT------------| |--------------------| |--------------------|
| MAX ??| | ??| | ??|
| Power-On Self Test | | | | |
| PASSED. | | | | |
| Press any key... | | | | |
| | |--------------------| |--------------------|
| | | ??| | ??|
| | | | | |
| | | | | |
| | | | | |
| | |--------------------| |--------------------|
| | | ??| | ??|
| | | | | |
| | | | | |
| | | | | |
| | |--------------------| |--------------------|
| | | ??| | ??|
| | | | | |
| | | | | |
| | | | | |
Press Ctrl-n to move cursor to the next menu item. Press return to select it.
Press Tab to move to another window --- thick border indicates active window.
