Configuring the WAN Interfaces
Configuring ISDN BRI network cards
MultiVoice Gateway for the MAX— User’s Guide
Preliminary November 23, 1998
5-21
Phone number and Service Profile Identifier (SPID) assignments
Pri Num specifies the primary add-on number for the Net BRI line. If you configure the line
for point-to-point service, it is the only number associated with the line.
Sec Num is the secondary add-on number for the Net BRI line. If you configure the line for
point-to-point service, Sec Num is not applicable.
Pri SPID and Sec SPID are the SPIDs associated with the Primary and Secondary numbers,
respectively.
Examples of Net BRI configurations
This section provides examples of configuring Net BRI lines for switched connections and for
outbound calls.
Configuring incoming switched connections
The following example shows how to configure the BRI lines in multipoint mode with an NI-1
switch. To configure the lines for switched incoming connections:
1
Open Net/BRI > Line Config.
2
Assign a name to the profile and specify the carrier’s switch type:
Net/BRI
Line Config
Name=bri-net
Switch Type=NI-1
BRI Analog Encode=Mu-Law
3
Open Line 1, enable the line, and specify multipoint mode:
Line 1...
Enabled=Yes
Link Type=NI-1
4
Configure the B channels for switched usage and for routing to the local network:
B1 Usage=Switched
B1 Slot=9
B2 Prt/Grp=0
B1 Trnk Grp=
B2 Usage=Switched
B2 Slot=9
B2 Prt/Grp=0
B2 Trnk Grp=
5
Specify the primary and secondary add-on numbers and their associated SPIDs:
Pri Num=555-1212
Pri SPID=01555121200
Sec Num=555-1213
Sec SPID=01555121300
6
Close the Line 1 subprofile and proceed to configure the other 7 lines.
7
Close the Net BRI profile.
