Configuring Frame Relay
Configuring the logical link to a Frame Relay switch
MultiVoice Gateway for the MAX— User’s Guide
Preliminary November 23, 1998
7-7
Configuring a UNI-DCE interface
In this example, the MultiVoice Gateway has a nailed connection to customer premises
equipment (CPE), and the connection uses a UNI-DCE configuration, Figure 7-7 shows the
connection.
Figure 7-7. Example of UNI-DCE connection to an end-point (DTE)
To configure the Frame Relay profile for this connection:
1
Open a Frame Relay profile.
2
Assign the profile a name and activate it:
Ethernet
Frame Relay
Name=ATT-DCE
Active=Yes
3
Set the FR Type to DCE:
FR Type=DCE
4
Set up the nailed connection to the remote switch and specify the data service for the link.
For example:
Call Type=Nailed
Nailed Grp=1
Data Svc=64k
5
Specify the link management protocol and its configuration parameters. For example:
Link Mgmt=T1.617D
DCE N392=3
DCE N393=4
T392=15
6
Close the Frame Relay profile.
Configuring a UNI-DTE interface
In this example, the MultiVoice Gateway has a nailed connection to a Frame Relay switch
configured as a DCE, and the connection uses a UNI-DTE configuration. Figure 7-8 shows the
connection.
Figure 7-8. UNI-DTE connection to a Frame Relay switch
CPE
UNI-DTE
UNI-DCE
Multi
NO LINK
