Installing Asanté MacCon Cards
2-13
Installing the MacCon3 IIsi and MacCon 30i Cards
If you have a Macintosh IIsi or a Macintosh SE/30, use a MacCon3 IIsi
or a 30i to connect to the Ethernet. (The cards are not
designed for a Macintosh SE.)
Each card consists of two parts:
❏
The larger
controller
card, which plugs into the expansion
slot in the Macintosh.
❏
The smaller
daughter
card, which is mounted on the rear
access port to enable a connection to the Ethernet cable.
You connect the two cards with a ribbon cable after installing them.
Setting the Cable Type on the Daughter Card
With the 30iET and 30iE, set the cable type by
pressing the switch in the lower left corner on the daughter card.
Select the switch position, as specified in the table below, by press-
ing the switch with a pointed tool. With the 30iET, select
TPL if your hub supports link integrity; select TPN if it does not.
The MacCon3 card has autosensing ports and does not require a
switch to be set.
MacCon
+
30iET
30iE
TPL
10BaseT
Link integrity enabled
TPN
10BaseT
Link integrity not enabled
TK
Thick
TN
Thin
TK
Thick
TPL
TPN
TK
TN
TK
Switch
Switch
