AS MOTOR AS 940 SHERPA 4WD RC, Operator'S Manual

Page: 47 / 56

Possible faults
47
Possible faults
If a fault occurs, it is recommended to first switch off the Remote Control Transmitter using the start-stop switch and the device
using the main switch. Wait 10 seconds and restart the device. If required, also change the frequency (see Selecting radio fre-
quency [
}
28]).
If the fault persists, the following error codes describe the faults that occur most frequently and how to eliminate them.
If the fault cannot be eliminated, contact your closest authorized service center.
You can find an authorized service center on our home page under www.as-motor.de.
Problem Possible cause Remedy
No connection be-
tween Remote Control
Transmitter and re-
ceiver Battery in the Remote Control
Transmitter is empty. Replace battery.
Battery in the device is empty. Charge the battery (see Checking the
battery) or have authorized service cen-
ter do so.
Radio range exceeded. Reduce distance between Remote Con-
trol Transmitter and receiver.
Radio interference due to other
Remote Control Transmitters
(radio equipment, garage door
opener, vehicle key). Switch off Remote Control Transmitter
and receiver, restart after 10 seconds.
Switch the radio channel.
Abstand zur Störquelle vegrößern.
Störquelle entfernen.
The Emergency stop switch on
the device is activated. Unlock the Emergency Stop switch.
Antenna loose, damaged or no
longer existent. Fasten or replace antenna.
Starter does not turn MC mode:
Safety switches are not acti-
vated. Move drive lever to neutral position.
Put driver in seat to activate seat contact
switches.
Insert the Remote Control Transmitter
into the Remote Control Transmitter
holder.
An Emergency stop situation
occurred. Eliminate the Emergency stop situation.
Fuse is defective. Replace (if necessary, have authorized
service center do so).
Battery in the device is empty. Charge the battery (see Checking the
battery) or have authorized service cen-
ter do so.
Battery in the device is defec-
tive. Replace battery (authorized service cen-
ter).
Engine does not start Fuel valve is closed. Open fuel valve.
Tank ventilation screw is closed. Open tank ventilation screw.
No fuel is in the tank. Refill fuel.
Choke is open. Close the choke.
Device was tilted – oil leaked
into the air filter. Replace air filter, unscrew spark plug
and start several times when the fuel
valve is closed, dry the spark plug and
screw it back in.
Engine was flooded due to too
many start attempts. Unscrew spark plugs and start several
times when the fuel valve is closed, dry
the spark plugs and screw them back in.
Spark plug connector is pulled
off. Observe the safety instructions! Put
spark plug connector back on.