Working in the MC mode
29
ð
Engine is started.
ð
The oil control light (13) on the Remote Control Trans-
mitter goes out.
3.
Only after cold start:
Move the accelerator lever to middle position (full throttle).
Steering in the MC mode
In the MC mode, steer with the steering wheel.
The joystick for the steering and trimming will not function in
the MC mode.
Driving in the MC mode
Warning
Risk of injury during driving forward and in reverse.
► Make sure no other persons stand in front of or behind
the device and that your path is clear of obstacles.
► Make sure that no other persons, children or animals
are transported.
Warning
Device can move jerkily. If you are standing on the device,
injuries can result.
► Remain seated and do not stand up while the device is
moving.
► Do not drive while standing up.
Warning
Driving on slopes is dangerous. There is a tilting and slip-
ping hazard.
► Observe the safety instructions regarding driving on
slopes.
► Observe the information in chapter Operating modes.
In case of a hazardous situation, switch off the drive and dis-
engage the blade.
Brakes
Warning
The foot brake does not take effect if you hold on to the ac-
celerator lever during braking.
► Release the accelerator lever when you activate the
foot brake.
In order to stop, move the drive lever slowly to neutral posi-
tion.
The parking brake stops the rear wheels. When the foot
brake is activated, the drive lever moves all the way to neu-
tral position/parking brake.
Activate the foot pedal only in exceptional circumstances be-
cause the device stops abruptly.
Driving
1. Release the parking brake.
2. Move the drive lever slowly to the desired driving direc-
tion.The move you move the lever away from the neutral
position, the faster the mower moves.
3. To stop move the drive lever slowly to neutral position or
step on the foot brake.
Reversing
Always reverse slowly. Be especially cautious when the
blade is engaged.
Setting the cutting height
8
Fig. 20:
Continuously adjust the cutting height with the toggle
switch (8) from 1 to 5. The current setting is displayed on the
cutting height display on the device.
Up
Down
Cut. Height
Higher cutting height:
Continue to press the toggle switch forward
until the desired cutting height is reached.
Lower cutting height:
Continue to press the toggle switch back-
ward until the desired cutting height is
reached.
Highest cutting height:
Tap the toggle switch once briefly out of the
transport position to the rear.
Engaging the blade in the MC mode
Warning
Risk of injury due to rotating blade.
► Make sure that no persons, children, animals or objects
are in the danger area.
Warning
Risk of injury caused by ejected objects.
► Never mow when persons, children, pets or objects are
in the danger area.
Only engage the blade when it can rotate freely and does not
touch objects or the ground.
Do not engage the blade in uncut grass because when over-
loaded, the blade can be damaged or wear prematurely.
Requirements
– The Remote Control Transmitter is in the Remote Control
Transmitter holder.
– There is a driver in the driver’s seat.
– The engine is running.
– The oil control light is off.
Summary of Contents for AS 940 SHERPA 4WD RC
Page 56: ......
