Vor dem Starten
27
– The device cannot be operated any longer, also in the MC
mode.
Checking the battery
15
1
Fig. 16:
1. Switch on the Remote Control Transmitter using the start-
stopp switch (1).
ð
In the display (15) .
ð
In the display (15) a dot jumps back and forth: The
battery is ok.
ð
The display (15) flashes an “L”: Warning low battery
capacity. You can continue to operate the Remote
Control Transmitter for approx. 30 minutes.
Notice:
If the batteries are unsuitable or faulty, this test can
produce an incorrect result. Wechseln Sie dann die Batterien.
Changing the batteries
1. Move the device to a safe position and switch it off.
2. Loosen the locking screw at the battery compartment and
remove the cover.
3. Replace the batteries with 2 new batteries or 2 charged
batteries.
4. Close the cover and tighten the locking screw.
5. Switch on the Remote Control Transmitter via the start-
stop switch.
6. Check if a dot is jumping on the display.
Sitzposition einstellen
Verstellen Sie den Sitz in Längsrichtung, bis Ihre Füße auf
den schrägen Stützblechen stehen und Sie angenehm sitzen.
Sitzfederung einstellen
The seat suspension should be adjusted to the driver’s
weight and the terrain conditions. You will be most comfort-
able on the seat if you use the full suspension travel.
The seat suspension should be set as soft as possible to
keep it from going coil-bound during normal operation. The
current setting is displayed on the scale on the seat.
If the seat suspension goes coil-bound during normal opera-
tion, turn the handwheel clockwise. The indicator moves to-
wards 5. Seat suspension becomes stiffer.
If the seat suspension is stiff during normal operation and
thus uncomfortable, turn the handwheel counterclockwise.
The indicator moves towards 1. Seat suspension becomes
softer.
Guide values for the driver weight on flat terrain:
lb
kg
Scale
110
50
≥ 2
200
90
≥ 3
290
130
≥ 4
Bügel aufklappen
For safety reasons, always use the device with the rollbar
folded up and locked. If the device tips over, the bar can pre-
vent the device from rolling. Serious damage to the device
can be thus avoided.
The device may only be used with the rollbar folded down on
level ground.
Transport deposit
Warning
During loading there is an increased risk of tipping.
► Do not move on steep slopes when the transport rack is
loaded. Pay attention to the admissible loading limits.
The device has a transport rack above the engine cover.
Warning
Risk of accident due to inaccessible control elements at
the rear end.
► Make sure that the Emergency Stop and the selector
lever operating modes are always freely accessible.
Notice
There is a hazard that due to incorrect loading the engine
overheats and is damaged.
► Only load the transport rack so that the ventilation grid
located below is not covered.
Loading limits
Maximum load:
11 lb
(5 kg)
Maximum height:
7,1 in
(18 cm)
Maximum width:
17,7 in
(45 cm)
Maximum length:
11.8 in
(30 cm)
Summary of Contents for AS 940 SHERPA 4WD RC
Page 56: ......
