Artistic SD-16, User Manual

Page: 28 / 72

Page 28
Artistic Quilter SD-16 User Manual
Motor Speed Sensor Test
The “Speed” Sensor test can help you determine whether
or not there is a problem with the Artistic Quilter SD-16
speed sensor. Before performing this test, remove the
bobbin case and the top thread. Press the foot pedal so
that the machine will begin slowly rotating. The white
box will show a number that should stabilize at 100 if the
sensor is functioning properly. Release the foot pedal to
stop the ma chine. (Figure 39)
Press the “Main” button to return to the “Main” menu
screen or the “Back” button to return to the “More”
menu screen.
Pedal Test
The “Pedal” test can help you determine if there is a
problem with the Artistic Quilter SD-16 foot pedal. As
you slowly depress the foot pedal a percent of depression
will appear in the white box. The foot pedal should be
controllable from 0 to 100%. (Figure 40)
Press the “Main” button to return to the “Main” menu
screen or the “Back” button to return to the “More”
menu screen.
System Information Screen
The serial number of the machine is displayed at the top of
the System Information screen. This number matches the
one found on the label at the back of the machine.
Information contained in the white boxes below the
serial number identifies the electronics board revision
numbers as well as the firmware revision numbers of the
Artistic Quilter SD-16.
The Lifetime and Trip (or project) stitch counters count
the number of stitches the machine is performed. The
Lifetime count is the total number of stitches made since
the machine was built. The Trip Counter can be reset to
keep track of the number of stitches made during a given
project. To reset this counter, press the blue “Reset”
button found aligned with the Trip counter.
The Lifetime counter cannot be reset and should be
used as an indicator to determine when general machine
maintenance should be performed by an authorized
Artistic Representative. (Figure 41)
Press the “Main” button to return to the “Main” menu
screen or the “Back” button to return to the “More”
menu screen.
Figure 39
Figure 41
Figure 40
Remove bobbin case and top
thread. Clear all objects from the
needle area. Depress foot pedal
completely.
Passing test:
The value stabilizes at 100.
Remove bobbin case and top
thread. Clear all objects from the
needle area. Depress the foot
pedal completely.
Passing test:
Value below varies from 0 to 100%
173
45%
000005335
000005335