Artistic SD-16, User Manual

Page: 15 / 72

ArtisticCreativeProducts.com
Page 15
Changing the Hopping Feet
Your machine comes with
two hopping feet: a ruler
foot and an open-toe foot.
Use the ruler foot for ruler
work and everyday quilting,
and the open-toe foot when
you need greater stitch
visibility (such as micro
quilting).
1. Remove the foot that is
on the mount by using
the 2.5mm Allen wrench
to loosen the mounting
screw far enough that
you can slide the foot off
of the mount.
2. Slide the desired foot
onto the mount (Figure
7). Note that the opening
on the side of the foot is
lined up with the screw
hole. Push the foot up as
far as it will go.
3. Ensure the middle of the
foot opening is centered
with the needle when
the foot is fully tightened
with the 2.5mm Allen wrench. If it isn’t properly
centered, loosen the lock nut; center the foot with the
needle; hold the foot in position; and firmly tighten the
lock nut (Figure 8).
Figure 7
Figure 8