Artistic SD-16, User Manual

Page: 46 / 72

Page 46
Artistic Quilter SD-16 User Manual
Adjusting the Bobbin Sensor
Assembly
The Stop Sensor is adjusted at the factory for an M-class
bobbin with bobbin weight (fine) thread. If you prefer
more or less thread on your bobbin, the sensor can be
changed with a simple procedure.
1. Fill a sample bobbin with your chosen thread, allowing
the bobbin winder to stop automatically.
2. If the bobbin was wound with too much thread, loosen
the bobbin stop sensor’s adjustment screw enough to
be able to move the sensor assembly (Figure 10).
Move the sensor assembly toward the bobbin, until the
embossed line on the assembly reaches to a just before
where you want the bobbin to stop filling. Retighten the
adjustment screw.
3. Place an empty bobbin on the bobbin post, thread
the Artistic Quilter Bobbin Winder and press the start
(green) button to start the winder. When the sensor
stops the winder, press the green button until the
bobbin is as full as you want.
4. Re-adjust the sensor by loosening the adjustment screw
enough to be able to move the sensor assembly. Move
the assembly until the LED indicator turns on, then
move the assembly back slightly and tighten the screw.
Bobbins will now fill with thread to your chosen amount
of fullness, as long as you are filling the same size
bobbin.
5. You have the flexibility of resetting the sensor for
different bobbins and thread types by following
Steps
1-4 above.
Sensor Assembly
Adjustment Screw
Figure 10
Embossed
Line