Artistic SD-16, User Manual

Page: 61 / 72

ArtisticCreativeProducts.com
Page 61
2. Install remaining end of Controller Charging Cable into
the Controller as shown in Figures 4 & 5 .
Figure 5. Charging cable installed. Note flat
on cable is up.
Figure 4. USB Mini-B style charging port on the
Controller.
3. With the machine and Controller turned off, install the
Machine Interface Cable Connector to the machine foot
pedal port (Figure 6). Secure the connector by turning the
screw shafts (Figure 7).
Figure 6.
Figure 7.
4. The Receiver may sit on top of the table or on the shelf
below the table. It may also be attached to the machine
using the Velcro® strips provided, to secure it to the side of
the control or power pod.
5. Plug the power module into a power outlet and turn
units on in the following order:
1. Machine
2. Receiver
3. Controller