Electromagnetic Emissions
DualWave Arthroscopy Pump
User’s Guide
LM1-0630-EN_E
Page 40 of 43
Electromagnetic Emissions
14.0
Table 16
Guidance and Manufacturer's Declaration - Electromagnetic Emissions
The AR-6480 DualWave Arthroscopy Pump is intended for use in the electromagnetic environment specified below. The
customer or the user of the AR-6480 DualWave Arthroscopy Pump should assure that it is used in such an environment.
Emissions test
Compliance Electromagnetic environment – guidance
RF emissions
CISPR 11
Group1
The AR-6480 DualWave Arthroscopy Pump uses RF energy only for its
internal function. Therefore, its RF emissions are very low and are not likely
to cause any interference with nearby electronic equipment.
RF emissions
CISPR 11
Class A
The AR-6480 DualWave Arthroscopy Pump is suitable for use in all
establishments other than domestic and those directly connected to the public
low-voltage power supply network that supplies buildings used for domestic
purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Complies
Table 17
Guidance and Manufacturer's Statement - Electromagnetic Immunity
The AR-6480 DualWave Arthroscopy Pump is intended for use in the electromagnetic environment specified below. The
customer or the user of the AR-6480 DualWave Arthroscopy Pump should ensure that it is used in such an environment.
Immunity test
IEC 60601 test level
Compliance level
Electromagnetic environment - guidance
Electrostatic
discharge (ESD)
IEC 61000-4-2
± 6 kV contact
± 8 kV air
± 6 kV contact
± 8 kV air
Floors should be wood, concrete or ceramic tile. If
floors are covered with synthetic material, the
relative humidity should be at least 30%.
Electrical fast
transient/burst
IEC 61000-4-4
± 2 kV for power
supply lines
± 1 kV for
input/output lines
± 2 kV for power
supply lines
± 1 kV for
input/output lines
Mains power quality should be that of a typical
commercial or hospital environment.
Summary of Contents for AR-6480
Page 2: ......
