Array electronic AF-10MR-A2, User Manual

Page: 46 / 129

Chapter IV Programming on FAB2 panel
USER'S MANUAL
Fig 4.4 Function Interface
4.3.1 FAB2/Rom Interface
When the user enter into the FAB2/Rom interface as shown in Fig 4.5, then
when the user enters the Calibrate interface, Rom → FAB2 interface and FAB2_
Addr interface under the FAB2 function interface, the FAB2 machine will stop
running.
Fig 4.5
Calibrate Analog calibration
Rom→FAB2 Read FAB2 program
FAB2_Addr View or set the FAB2 address (default address 000)
MODEM System Reserved (FAB2 is not enabled for this feature)
4.3.1.1 Analog Calibration Interface
The analog channel calibration method is as follows,
1.When the user enters the Calibrate interface as above, please kindly press and
hold the ok and > keys on the LCD panel to enter the calibration page.
Separate each analog channel by analog (AI1 corresponds to I1), and input the
channel number to be calibrated, and press OK to confirm.
> Editor..
FAB2/Rom
Set..
Run
> Calibrate
Rom → FAB2
FAB2_Addr
MODEM
45