Array electronic AF-10MR-A2, User Manual

Page: 32 / 129

Chapter III General Description of Function Blocks
USER'S MANUAL
Notes regarding the time “CW”:
1. When the date system is selected for the timing of a time switch
A. For the same output channel, up to 127 time switches can be set, and these
switches must be put in order according to the time sequence, e.g.
On: May 1st, 2018 9:00
Off: May 2nd, 2018 18:00
On: Aug 2nd, 2018 10:00
Off: Aug. 2nd, 2018 19:00
The above arrangement is correct, while the below arrangement is wrong:
On: May 1st, 2018 19:00
Off: May 1st, 2018 18:00
On: Apr 2nd, 2018 8:00
Off: Apr. 2nd, 2018 5:00
B. During the time setting of the time switch, if two time-points (on and off) are
set, the output is on only in this period, that’s, time from on to off. Before the
time the output maintains the former status, while after the off time the output is
off.
2. The range of T1 (On time) and T2 (Off time)
You can set T1 or T2 to be any time point of the time period from 00:00:00 to
23:59:59. If you set T1 or T2 to be 24:00:00, it means that you have not set the
ON time or OFF time, so we can set some special time intervals in a combination
way by using an intermediate relay. (For example, a time interval without pre-set
choices in a week, like “6:00 on Monday, ON and 7:00 on Wednesday, OFF”)
e.g.6:00 on Monday, ON and 8:00 on Tuesday, OFF
How can we get the logic result of the above on the FAB panel?
Firstly: you should select MO, and set it as follows.
This setting means no OFF time
Q1
Q2
D/W
Q1
6:00
24:00
31