Aritech 1X-X3, Installation Manual

Page: 49 / 88

Chapter 3: Configuration and commissioning
1X-X3 Installation Manual 43
Fire sounder operation during a zone test
Use this menu to configure the sounder operation during a zone test. The default
setting for all operating modes is ON.
To configure the sounder operation during a zone test:
1. Set the display as shown below, and then press Enter.
The Fire Sounders Start/Stop LED flashes fast to indicate that the sounder
operation during a zone test configuration menu is active.
2. Select a value using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your changes.
The available settings for this feature are shown below.
Display Description
The internal buzzer and sounders sound for 5 seconds
when an alarm is activated in a zone test.
The internal buzzer and sounders do not sound when an
alarm is activated in a zone test.
Fire sounder re-sound
Use this menu to configure the sounder re-sound, on or off. This determines
sounder operation in a fire alarm event when sounders have been silenced by
pressing the Fire Sounder Start/Stop button and a new alarm event is reported in
a different zone. The default setting is ON.
To configure the sounder re-sound:
1. Set the display as shown below, and then press Enter.
The Sounders Start/Stop LED flashes fast to indicate that the sounder re-
sound configuration menu is active.
2. Select a value using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your change
The available settings for this feature are shown below.