89
6. Thread the cutter cable through hole (8) and route it to the
JP16 connector (CUTTER) on the
X-1000VL/ X-2000V/
X-2000V Zip
main boards, or to the JP14 connector
(CUTTER) on the main board of
X-3200/ X-3200Z/
X-3200E/ X-3200ZE/ X-2300E/ X-2300ZE
.
7. Turn on the printer.
8. For the X-2000V/ X-2000V Zip/ X-3200/ X-3200Z/ X-3200E/
X-3200ZE/ X-2300E/ X-2300ZE models with LCD, set the
parameter of “CUTTER INSTALLED” on the LCD to the ON
position. For the X-1000VL model, ignore this step.
After the cutter is installed, install media and ribbon.
1. Put the media end on the roller.
2. Close the print head latch.
3. Hold the PAUSE button and turn on the printer.
4. Release the button when the cutter starts cutting.
5. After cutting, the printer will feed the label for 8 inches.
Note:
The procedure above is for first time installation or after
cutter jam. Normally the procedure for loading the media
through the cutter is:
1. Put the media end on the roller.
2. Close the print head latch.
3. Turn on the printer.
4. Press the FEED button to feed the media end through
the cutter.
Summary of Contents for Xellent X-1000VL
