51
Resetting to Factory Default Settings
To reset the printer to factory default settings:
1. Turn off the printer.
2. Press and hold the CANCEL button and turn on the
printer.
3.
When “RESET …” is displayed on the LCD and the
READY indicator blinks, release the CANCEL button.
(The Ethernet models will first
prompt “ETHERNET CARD
INITIALIZING” on LCD after Power-on and then show the
“RESET …” message as described above.)
4.
When “READY” is displayed on the LCD, the READY
indicator stops blinking but remains illuminated.
5. The following information is now back to defaults:
Label parameters
Heat (Darkness)
Speed
Symbol set (language)
Others for specific emulation
Notes:
1. For X-1000VL, the steps about LCD can be ignored.
2. Be cautioned that this will reset all printer settings back to
defaults; if possible, print the configuration label in
advance before reset.
3. All settings stored in FLASH memory are retained even
after turning off the printer.
4. You must perform the calibration after resetting the printer.
Summary of Contents for Xellent X-1000VL
