DMX-CAN Manual
page 28
rev 1.6
1.
Enter new target position here.
2.
Start on-the-fly-position change operation.
K.
On-The-Fly-Speed
Figure 6.15
1.
Desired Speed – Once the “Set Speed” button is clicked, the speed will
change on-the-fly to the desired speed.
2.
Desired Acc/Dec – The acceleration/deceleration use for the on-the-fly
speed change operation
3.
Before setting the DMX-CAN into motion, set the
SSPDM
parameter.
To see which to use, see the on-the-fly speed change section.
4.
Set the
SSPDM
parameter. Note that is an on-the-fly speed change
operation is to be used, this parameter must be set before the controller
goes to start motion.
5.
Set
SSPD[value]
– Start the on-the-fly speed change operation.
2
3
4
1
5
