3-52
NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
Installing
Engine/Transmission
NOTE: Arctic Cat recommends that new gaskets
and O-rings be installed whenever servicing the
ATV.
1. Turn the front driveline to place the output drive
yoke universal joint in the horizontal plane; then
secure the driveshaft to the right and against the
engine.
GZ117A
2. Install the engine/transmission into the frame from
the right side.
3. Rotate the driveshaft 90°; then lift the front of the
engine sufficiently to engage the splined shaft into
the front differential. Lower the front of the
engine.
GZ110A
GZ119
4. Align the rear output drive flange and the rear
driveshaft yoke flange and install the cap screws.
Tighten to 20 ft-lb.
5. Align the engine with the mounting brackets and
install the through-bolts with flat washers; then
install the flange nuts and tighten to 45 ft-lb.
6. Connect the coolant hose and tighten the clamps
securely.
7. Secure the engine and harness grounds to the
engine and tighten the cap screw to 8 ft-lb.
GZ064A
8. Install the ignition coils and tighten the cap screws
to 12 ft-lb; then connect the primary wires,
grounds, and spark plug caps.
9. Connect the stator coil connector and crankshaft
position sensor connector; then connect the gear
shift position switch connector.
GZ069A
AT THIS POINT
After completing center crankcase components, pro-
ceed to Installing Right-Side Components, to Install-
ing Left-Side Components, and to Installing Top-Side
Components.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
