6-22
GZ180
GZ182A
4. Remove the snap ring retaining the input bearing
and using an appropriate bearing driver, press the
bearing from the housing.
GZ184A
Cleaning and Inspecting
1. Wash all parts in parts cleaning solvent and dry
with compressed air.
2. Clean all gasket material and sealant from mating
surfaces.
3. Inspect bearings, shafts, and housing for excessive
wear, cracks, or discoloration.
4. Inspect the clutch basket for wear in splines or
cracks in the housing.
GZ178A
5. Inspect the clutch pack for signs of discoloration.
NOTE: The clutch pack is not a serviceable com-
ponent. If worn, discolored, or damaged in any
way, it must be replaced.
Assembling/Installing
1. Install either the existing or a new bearing into the
input housing and secure with the snap ring (flat
side directed away from bearing).
GZ184
2. Using a suitable seal driver, install a new oil seal
into the front of the input housing until the seal
flush with the housing.
GZ182A
3. Apply grease to the lips of the oil seal; then install
the input shaft into the input bearing and housing.
! WARNING
Always wear safety glasses when working with com-
pressed air.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
